Mustek PP3000 Bedienungsanleitung PDF herunterladen (Seite 57)

4 - 17

PST-7000 series user’s manual – USING THE PST SYSTEM

• RWM.EXE – This is a straight through programming utility used under DOS

environment.

• KBM.EXE – This is a detail programming utility applicable under DOS,

WINDOWS 3.1, WINDOWS95 and so on.

• HOT KEY PROGRAMMING – This is the most convenient (maybe less

efficiently) programming method applicable under any environment. This is also

the method most possibly used by the end user for instant content update. This will

be further discussed in next section.

INSTANT CONTENT UPDATE

If you want to update the key definition of any key in the PST keyboard, this

instant content update feature serves the purpose best. However, this method

programs only the normal displayable characters for the key definitions. The instant

content update utilizes the Hot Key programming ability of the programmable

keyboard that can be arranged in four steps:

The preparation requires a standard PC or PS/2 keyboard connected to the

external keyboard connector of the PST7000 series in the front door area locked by

the mechanical key. To enter the Hot Key programming mode, the left “Alt” key and

the “PRT SC” (“Print Screen”) key on the PC or PS-2 keyboard must be pressed at the

same time and after two beeps from the system, the key on the programmable

keyboard to be updated must be pressed. The user should then use either the PC or

PS/2 keyboard or the connected CCD scanner to input the content to be programmed

for that key. To exit the Hot Key programming mode, the user has to press both the

left “Alt” key and the “PRT SC” (Print Screen) again. The system gives one beep here

to notify a successful input, three beeps for input failure.

Preparation

Enter “hot key

programming”

mode

Input the

content to be

programmed

Exit “hot key

programming”

mode

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 66 67

Keine Kommentare

Mustek PP3000 Bedienungsanleitung Seite 57