Mustek PP3000 Bedienungsanleitung PDF herunterladen (Seite 36)

3 - 16

PST-7000 series user’s manual – BRIEF INTRODUCTION

Fig. 3 - 12 Installation of internal KB wedge device

PS/2 MOUSE

Unscrewing the 2 screws near the front bottom corners with the front door

unlocked, the programmable keyboard section can be raised up exposing part of the

EMI protection shield over the mainboard. On the front edge of the mainboard, there

is the PS2 mouse port. After connecting a PS2 mouse to this PS2 mouse port, please

remove the cable stopper on either side of the chassis and route the mouse cable

through the side opening before screwing back the keyboard section.

After the mechanical installation of the PS/2 mouse, the user should enable the

function of this mouse in the CMOS setup. Enter the CMOS setup by pressing “DEL”

key at system boot up, choose for “INTEGRATED PERIPHERALS” and make the

“PS/2 MOUSE” enabled. Save the configuration and exit the CMOS setup program.

The PS/2 mouse will then be ready for the control of the operation system.

5PIN DIN MALE

DIN JACK

KB CPU BOARD

5PIN DIN MALE

5 PIN DIN FEMALE

SCREWS

CABLE OF INTERNAL

KB WEDGE DEVICE

Lift up front end after

unlocking and unscrewing

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 66 67

Keine Kommentare

Mustek PP3000 Bedienungsanleitung Seite 36