Mustek PP3000 Bedienungsanleitung PDF herunterladen (Seite 22)

3 - 2

PST-7000 series user’s manual – BRIEF INTRODUCTION

When the cover plate of the 1

IDE HDD window is removed, one can see the

IDE HDD is screwed on the cover plate through 4 screws with rubber washers on

both sides of the cover plate. Replace the HDD by unscrewing the 4 screws with

rubber washers and disconnecting the data and power connection to the HDD by a

qualified technician only when neccessary. Please always remember to put the

rubber washers back on bothe sides of the cover plate to protect the HDD.

Opening the window for system battery & DRAM, there are three openings in

the bottom chassis. The system battery socket in one opening, the two SO DIMM

sockets in another and there is another opening for reserves.

The battery socket accepts a 3 V button cell Lithium battery (CR2032)

required to support the system real time clock. A new Lithium battery can support the

system RTC for about 3 years. After the battery is nearly exhausted, the user must

change a new battery otherwise the system RTC and system configuration setup will

be lost. The two SO DIMM sockets accept Small Outlined Dual In-line Memory

Module each may be up to 256 MB.

Unscrew the 4 screws with rubber washers to

remove the 1

IDE HDD. Always put on the

rubber washers when screwing back the HDD.

Reserved opening

Socket for System Battery

System Battery

SO DIMM

SO DIMM Sockets

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 66 67

Keine Kommentare

Mustek PP3000 Bedienungsanleitung Seite 22