Mustek POWERMUST 2016 ONLINE LCD Bedienungsanleitung

PowerMust 1008 Online LCD & RM PowerMust 2016 Online LCD & RM PowerMust 3024 Online LCD & RM Online UPS User Manual EN

9 Display Function Backup time information Indicates the backup time in pie chart. Indicates the backup time in numbers. H: hours, M: minute,

10 3-3. Audible Alarm Battery Mode Sounding every 4 seconds Low Battery Sounding every second Overload Sounding twice every second Fault Contin

11  01: Output voltage setting Interface Setting Parameter 3: Output voltage For 208/220/230/240 VAC models, you may choose the following output

12 LLS: Low loss voltage in ECO mode in parameter 2. For 208/220/230/240 VAC models, the setting range in parameter 3 is from -7V to -24V of the nomi

13 3-6. Operating Mode Description Operating mode Description LCD display Online mode When the input voltage is within acceptable range, UPS will

14 3-8. Warning indicator Warning Icon (flashing) Alarm Low Battery Sounding every second Overload Sounding twice every second Battery is not

15 4. Troubleshooting If the UPS system does not operate correctly, please solve the problem by using the table below. Symptom Possible cause Re

16 Symptom Possible cause Remedy Fault code is shown as 14 and the icon is lighting on LCD display and alarm is continuously sounding. The UPS

17 MODEL PowerMust 1008 Online LCD PowerMust 2016 Online LCD PowerMust 3024 Online LCD CAPACITY* 1000 VA / 800 W 2000 VA / 1600 W 3000 VA / 2400

1 Table of Contents 1. Important Safety Warning……………………………………………… 2 1-1. Transportation 2 1-2. Preparation 2 1-3. Installation 2 1-4. Operation 2

2 1. Important Safety Warning Please comply with all warnings and operating instructions in this manual strictly. Save this manual prope

3 1-5. Maintenance, service and faults  The UPS system operates with hazardous voltages. Repairs may be carried out only by qualified maintenance p

4 2. Installation and setup NOTE: Before installation, please inspect the unit. Be sure that nothing inside the package is damaged. Please keep the

5 12. Output circuit breaker

6 2-2. Setup the UPS Step 1: UPS input connection Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using extension cords.

7 Step 5: Disable and enable EPO function Keep the pin 1 and pin 2 closed for UPS normal operation. To activate EPO function, cut the wire between pi

8 3. Operations 3-1. Button operation Button Function ON/Mute Button  Turn on the UPS: Press and hold ON/Mute button for at least 2 seconds to